Anti-Calc System - Breville VIN067 Instructions For Use Manual

Anti-calc system

The anti-calc cartridge should be
replaced when the 'change cartridge'
indicator illuminates. If a new
cartridge is not immediately available,
you may continue ironing, using
distilled water in place of tap water.
IMPORTANT
When the anti-calc
cartridge is exhausted, do
NOT continue to use the iron
with tap water as this may
damage the iron.
NEVER attempt to use the
iron without the anti-calc
cartridge in place.
Replacing the anti-calc
cartridge
1 Switch off and unplug the steam
generator at the mains supply.
2 Remove the water tank, by
pressing the release button
located on the underside of the
tank. (Fig 1).
NOTE:
The cartridge will contain a
small amount of water. Keep
the cartridge tilted upwards to
minimise dripping from the
connecting tube.
3 Lift the anti-calc cartridge from
the water tank and dispose in
the household waste (Fig 2).
4 It is recommend that you empty
and refill the water tank with cold
water at this point. Do not fill the
water tank above the 'MAX' mark.
USING YOUR IRON
Fig 1
Release Button
Fig 2
5
6
Resetting the Anti-calc system
after replacing the cartridge
1
2
3
4
9
Insert the new cartridge into the
top of the water tank. Push the
cartridge down, ensuring the
water-outlet rests in the recess
on the water tank.
Insert the tank into the base unit,
ensuring that it latches securely
into place.
Switch off and unplug the steam
generator at the mains supply.
Whilst pressing and holding the
Power on/off button and the
Steam level selector, plug the
steam generator back into the
mains supply.
Release both buttons.
This will reset the Anti-calc
system and the 'change
cartridge' indicator will turn off.
9 9