Using Your Iron; First Time Use - Breville VIN067 Instructions For Use Manual

First time use

1 When the iron is connected to the
mains supply and the power ON/
OFF button is pressed you will
hear a single beep.
2 The heat indicator on the control
panel will light to show that the
steam generator is preheating.
3 The minimum (LOW) steam
setting is selected by default.
Select the highest setting (HIGH).
4 Press the temperature / standby
select button on the iron handle
to set the soleplate temperature
to its maximum setting.
The iron will now start to heat up
and the temperature indicator
light on the handle will flash.
When the iron has reached the
desired temperature, the light will
stop flashing and light
continuously. The iron is now
ready to use.
The temperature indicator lights
will flash on and off during
ironing as the iron maintains the
soleplate temperature.
If the iron is not up to full
temperature before you use it,
water will leak through the
soleplate. If this happens, stop
using the iron until the
temperature indicator light stops
flashing to indicate that the iron is
up to temperature again.

USING YOUR IRON

5
6
6
Press the steam button for 30
seconds to clean the steam
generating system.
NOTE:
You will hear a repeated
buzzing sound as the pump is
primed ready for use. The
noise will subside after a
short time. This is NOT a
fault.
Iron an old towel to ensure that
any residues inside the iron are
not transferred to your good
laundry.
If you find it necessary to clean
the soleplate, allow the iron to
completely cool down then wipe
over it with a slightly damp cloth.
WARNING!
During use the hot water
pipe and iron rest become
very hot, avoid contact,
especially if you have
sensitive skin.