Table of Contents
Advertisement
Step 13. Lighting the Fireplace
You've reviewed all safety warnings, you've checked the
fireplace for gas leaks, you know the vent system is
unobstructed, and you've checked for faulty components.
Now you're ready to light the fireplace.
FOR YOUR
SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS EXACTLY, A FIRE
OR EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY,
OR LOSS OF LIFE.
IPI IGNITION
A. This appliance is equipped with an intermittent pilot
ignition (IPI) device which automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
WARNING: THIS APPLIANCE IS EQUIPPED
!
WITH TWO AUTOMATIC RESET, HIGH TEM-
PERATURE LIMIT SWITCHES. IF, DURING NORMAL
OPERATION THE APPLIANCE CYCLES ON AND OFF,
REFER TO "POSSIBLE CAUSE" ITEM #6f IN THE
TROUBLESHOOTING GUIDE.
18
Heat & Glo • 6000PLUS • 2063-900 Rev. E • 11/05
LIGHTING
INSTRUCTIONS (IPI)
1. STOP! Read the safety information on page 2 first!
2. Turn off all electric power to the appliance.
3. This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
GAS
VALVE
4. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the Safety Information located
on the previous pages. If you don't smell gas, go to
next step.
5. Turn on all electric power to the appliance.
6 To light the burner, flip the ON/OFF switch to the "ON"
position. (The ON/OFF switch may include a wall
switch if so equipped).
7. If the appliance will not operate, follow the instruc-
tions "To Turn Off Gas to Appliance" and call your
service technician or gas supplier.
TO TURN OFF
GAS TO APPLIANCE
1. Turn off all electric power to the appliance if service is
to be performed.
2. Flip ON/OFF switch to the "OFF" position.
After the Installation
LEAVE THIS INSTALLATION MANUAL WITH
!
THE USER FOR FUTURE REFERENCE.
Advertisement
Table of Contents
