Initial Settings - Pioneer Super Tuner IIID DEH-3250UB Owner's Manual

Operating this unit
FAD/BAL (fader/balance adjustment)
You can change the fader/balance setting.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between fader and balance.
3 Turn M.C. to adjust speaker balance.
Adjustment range (front/rear): F15 to R15
Adjustment range (left/right): L15 to R15
FR 0 is the proper setting when only two speakers
are used.
EQUALIZER (equalizer recall)
There are six stored settings DYNAMIC (dynamic),
VOCAL (vocal), NATURAL (natural), CUSTOM (cus-
tom), FLAT (flat) and POWERFUL (powerful).
! When FLAT is selected no adjustments are made
to the sound.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the equalizer.
DYNAMIC—VOCAL—NATURAL—CUSTOM—
FLAT—POWERFUL
3 Press M.C. to confirm the selection.
TONE CTRL (equalizer adjustment)
You can adjust the bass/mid/treble level.
! Adjusted equalizer curve settings are stored in
CUSTOM.
1 Press M.C. to display the setting mode.
2 Press M.C. to select BASS (bass)/MID (mid)/TRE-
BLE (treble).
3 Turn M.C. to adjust the level.
Adjustment range: +6 to -6
LOUDNESS (loudness)
Loudness compensates for deficiencies in the low-
and high-frequency ranges at low volume.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the desired setting.
OFF (off)—LOW(low)—HIGH (high)
3 Press M.C. to confirm the selection.
SLA (source level adjustment)
SLA (Source level adjustment) lets you adjust the vo-
lume level of each source to prevent radical changes
in volume when switching between sources.
! Settings are based on the FM volume level, which
remains unchanged.
Before adjusting source levels, compare the FM
volume level with the level of the source you wish
to adjust.
! The AM volume level can also be adjusted with
source level adjustments.
1 Press M.C. to display the setting mode.
2 Turn M.C. to adjust the source volume.
Adjustment range: +4 to –4
3 Press M.C. to confirm the selection.
Notes
! When selecting FM as the source, you cannot
switch to SLA.
! Operation is complete even if the menu is can-
celled before being confirmed.

Initial Settings

1 Press SRC/OFF and hold until the unit
turns off.
2 Press M.C. and hold until CLOCK SET ap-
pears in the display.
3 Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
CLOCK SET (setting the clock)
1 Press M.C. to display the setting mode.
2 Press M.C. to select the segment of the clock dis-
play you wish to set.
Each time you press M.C., one segment of the
clock display is selected.
Hour—Minute
As you select segments of the clock display, the
selected segment flashes.
3 Turn M.C. to adjust the clock.
FM STEP (FM tuning step)
Section
01
11
En