Hitachi RAS-18SH3 Instruction Manual page 12

PREPARE THE REMOTE CONTROLLER (continued)
Ampere setting (Standard/Save) can be selected.
4
If you experience frequent circuit breaker tripping, set ampere to "Save" to avoid this problem.
(Ampere is set to "Standard" at the time of purchase.)
WHEN OPERATING THE REMOTE CONTROLLER
• Point the remote controller to the signal receiver of the unit
Signal reception distance is approximately 7m in front of the unit.
However, this distance may be shorter or the signal may not be
receivable if there is an electronic lighting device in the same room.
• Handle the remote controller with care
Dropping it or getting it wet may compromise its signal transmission
capability. After new batteries are inserted into the remote controller,
the unit require approximately 10 seconds before it can respond to
commands and begin operation.
Press the (FUNCTION SELECTOR)
1
button until
While (SAVE) is blinking, point the remote controller towards
2
the unit and press the
• A short beep sounds and
Press the
(SAVE) blinks.
While (SAVE) is blinking, point the remote controller towards
RELEASE
the unit and press the
• A short beep sounds and
the setting is released.
„ Notes for "save" setting
• If ampere is set to "Save", the maximum heating capacity slightly lowers
and starting up of heating operation will take a little longer. Besides,
the preset temperature may not be reached if outside temperature is
low.
– 12 –
(SAVE) blinks.
(ON/OFF) button.
(SAVE) indicator turns on.
(FUNCTION SELECTOR) button again until
(ON/OFF) button.
(SAVE) indicator turns off, indicates
Approximately
7m from the front