Setting Time And Date / Auto Clock - Daewoo SD-9100 Owner's Manual

DV6T712D-AQ/I(GB) 02.11.12 5:39 PM

Setting time and date / Auto clock

Setting time and date
I Press [VCR] button on the remote control to change into VCR Mode and follow the procedure
below.
Call the player's "MAIN SETUP",
1
choose "VCR SETUP", then "CLOCK SET".
Move to the position you want to change and type in the
2
new values.
Wait a few seconds after typing a one-digit number.
Store with [OK] button and exit with [SETUP] button.
Setting Auto clock
I
Auto Clock is only available for models with the VPS/PDC function (see page 25).
Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will
automatically use this time and date during the initial setting up procedure during normal use, and every time
you switch the video off at the mains. If you find that this time and date is incorrect you can remove this feature
by following the steps below changing it to OFF mode, you will then have to manually set the time and date, see
above.
VCR SETUP
CLOCK SET
LANGUAGE SET
RF OUTPUT SET
16:9 SET
OSD ON/OFF
AUTO CLOCK
PR+/-:SELECT
OK:CONFIRM
˘ ` 17 mac001 300DPI 120LPI
PR+/-:SELECT
OK:CONFIRM
SETUP:END
CLOCK SET
TIME - - : - -
DATE - - / - - /- - - -
0-9:SETUP (HOUR)
</>:CORRECT
CLOCK SET
TIME 06:05
DATE 10/03/2002(SUN)
0-9:SETUP (HOUR)
</>:CORRECT
OK:CONFIRM
AUTO CLOCK
ON
OFF
SETUP:END
SETUP:END
SETUP:END
17