Table of Contents
Advertisement
Quick Links
OPERATING INSTRUCTIONS
Thank you for purchasing Epos loudspeakers.
Please take a little time to read these brief notes, which will help you get the
best from your loudspeakers.
POWER REQUIREMENTS
Amplifiers with power outputs
between those specified will generally
be adequate, although more powerful
amplifiers can be used if care is taken
to avoid overdriving the loudspeakers.
Use
the
volume
control
discretion, and reduce the level
immediately if the loudspeakers begin
to distort. Amplifiers capable of less
than 25 Watts per channel output are
best avoided because they will restrict
the dynamic range. They may also
cause damage to the loudspeakers if
driven beyond their capability in an
attempt to obtain high volume levels.
The clipping distortion produced
when an amplifier is driven beyond
its normal output capability can be
very
destructive.
A
amplifier operating well inside its
capability will generally be less
likely to damage your loudspeakers
Mini-Monitor
LOUDSPEAKERS
than a lower power amplifier
operating
beyond
Do not make or break connections to
the amplifier when it is turned on!
POSITIONING
with
Space should be left behind the
loudspeakers
operation of rear firing reflex ports
and to ensure establishment of good
stereo
image
experimentation may be necessary to
establish the ideal position within
your listening room. Begin by
positioning the loudspeakers about
20cm (8")from the rear wall and
gradually move them out a little until
you achieve the best balance between
bass
weight
Avoid placing the loudspeakers in
powerful
corners because this may cause un-
welcome colouration of the midband
frequencies. Try to leave at least
40cm of space between each
its
capacity.
to
allow
proper
depth.
Some
and
definition.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EPOS Mini-Monitor
Summary of Contents for EPOS Mini-Monitor
-
Page 1: Operating Instructions
Mini-Monitor LOUDSPEAKERS OPERATING INSTRUCTIONS Thank you for purchasing Epos loudspeakers. Please take a little time to read these brief notes, which will help you get the best from your loudspeakers. POWER REQUIREMENTS than a lower power amplifier Amplifiers with power outputs... - Page 2 Remember, plug is evident. Once again, if you there is no absolute right or wrong - are in doubt consult your Epos if it sounds good, it is good. dealer, who will be able to offer this service.
- Page 3 The negative terminal on the amplifier left channel, marked RUNNING IN or coloured black, must be connected Epos loudspeakers require a little to the negative terminal on the left gentle use to allow their working loudspeaker. Repeat connections for components to settle into their proper the right channel.
- Page 4 REMEMBER ALWAYS lower the volume before making any adjustments to the system (e.g. switching amplifier inputs or raising or lowering pickup arm). switch off the amplifier before checking or making any changes to any connections in the system. NEVER try to find out how loud the system will go.
- Page 5 Mini-Monitor LOUDSPEAKERS SPECIFICATION Power Handling: 25 mm aluminium dome with high l00 Watt speech and music temperature voice coil and neodymium shielded magnet system Frequency Response: 65 Hz - 20 kHz Crossover: Bass driver crossover is achieved by Impedance: 3 components in a 2nd order filter...
- Page 6 United Kingdom only and given in addition to your statutory rights. Service enquiries in countries other than the United Kingdom should be addressed to the local Epos agent or distributor. Warranties granted in these countries are entirely at the discretion of the agent or distributor.
Need help?
Do you have a question about the Mini-Monitor and is the answer not in the manual?
Questions and answers