Subscribe to Our Youtube Channel
Related Manuals for EPOS Elan 35
Summary of Contents for EPOS Elan 35
-
Page 1: User Manual
Designed and engineered in the U.K. User Manual EPOS LIMITED 12 Avebury Court Mark Road Hemel Hempstead Herts HP2 7TA England Telephone: +44 1442 260146 Fax: +44 870 622 0846 E-mail: info@epos-acoustics.com www.epos-acoustics.com... -
Page 2: Cable Terminations
+ conductor and the black plugs are fitted to both ends of the negative or – conductor. If you are in doubt consult your Epos dealer. Residents of the European Union may wish to use bare wires into the terminal posts, as 4mm plugs have been outlawed. -
Page 3: Positioning And Fine Tuning
This will help preserve the outstanding mid-band clarity which is a hallmark of Epos loudspeakers. Epos has designed its own spiked stands for the stand-mount models. The floor-standing models are supplied with their own support plinth and spikes. - Page 4 To fit the cloth-covered grille, hold it with the Epos badge at the bottom and position the smaller of the two holes carefully over and around the tweeter, locate the metal pegs into the rubber sockets and gently push the grille on to the cabinet, evenly all around, until it is fully in place.
-
Page 5: Power Requirements
So, as a rough guide, the minimum amplifier power we recommend varies from 25W into 4 ohms for the Elan 10, to 10W into 4 ohms for the Elan 35 (please see the individual specifications). Although 100dB SPL maximums are very loud, these would occur only during the very loudest moments. -
Page 6: Long-Term Care
WARRANTY Your Epos Elan series loudspeakers have been built to very high standards and should give many years of trouble-free service. If within five years of purchase they prove to be defective for any reason other than accident, misuse, neglect, unauthorized modification or fair wear and tear, we will repair the defect or, at our option, replace the faulty speakers without charge for parts, labour or return carriage. -
Page 7: Specifications
Tweeter Epos 25mm soft dome with high-temperature voice coil, ferrofluid cooling and neodymium magnet system. Magnetically shielded Bass/Midrange Driver Epos mid bass 156mm dia., with cast chassis, 25mm high-temperature voice coil and polypropylene cone. Magnetically shielded Crossover Frequency 3.2kHz. Crossover Bass and tweeter networks both use 2nd order filters. - Page 8 Tweeter Epos 25mm soft dome with high-temperature voice coil, ferrofluid cooling and neodymium magnet system. Magnetically shielded Bass/and Bass/Midrange Drivers 2x Epos mid-bass 156mm dia., with cast chassis, 25mm high-temperature voice coil and polypropylene cone Crossover Frequencies 3.6kHz and 800Hz Crossover Bass, mid bass and tweeter networks all use 2nd order filters.
Need help?
Do you have a question about the Elan 35 and is the answer not in the manual?
Questions and answers