Toshiba RAS-24UKX Service Manual page 55

No. Part name
3
Horizontal grille
4
Heat exchanger
5
Cross flow fan
6
Bearing base
7
Fan motor
Procedures
1) Remove center 2 shafts of the horizontal
grille from the back body.
2) Remove left shaft of the horizontal grille
from the back body.
3) Remove the horizontal grille from the back
body.
1) Remove the front panel, electrical parts
assembly and the horizontal grille with
procedure 2 and 3.
2) Remove the screw on the rear side of the
main unit to remove the pipe holder.
3) Remove 2 screws fixing the heat ex-
changer and the bearing base.
4) Remove 2 screws fixing the heat ex-
changer fixtures (upper and lower) and the
back body then pull out the upper side of
the heat exchanger slowly.
1) Remove the front panel, electrical parts
assembly, horizontal grille and the heat
exchanger with procedure 4.
2) Loosen the set screw of the cross flow fan.
3) Remove 2 screws fixing the bearing base
and the back body.
4) Pull the cross flow fan toward you.
1) Remove the front panel, electrical parts
assembly, horizontal grille, heat exchanger
and the cross flow fan with procedure 5.
2) Remove the bearing from the bearing base.
If the housing protrudes from the base
bearing, put the housing in position and
assemble the bearing to the bearing base.
1) Remove the front panel, electrical parts
assembly, horizontal grille, and the heat
exchanger with procedure 4.
2) Loosen the set screw of the cross flow fan.
3) Remove 2 screws of the motor fixture.
4) Remove the lower side of the body (R) and
move it right to remove it.
5) Remove the motor from the motor fixture.
(2) Screw
Bearing base
When assembling the cross flow fan, fix it
with the set screw at the position where the
gap between the back body and the right
surface of the cross flow fan is 4 mm.
– 54 –
FILE NO. SVM-01010
Remarks
(1) Center shafts
(2) Left shafts
Pipe holder
(3) 2 screws
(4) 2
screws
(3) Screws
(2) Set screw
Bearing base
Bearing
(3) 2 screws
(4) BODY (R)
Motor fixture
(4)