Apeks Quantum Owner's Manual page 17

d. Maximum Operating Depth (MOD): MOD is calculated automatically and is
based on a PO
e. Safety Factor (SF): The safety factor may be set to 0, 1 or 2. When set to 0, the
computer will perform calculations based on the current altitude setting. If set
to 1, the calculations are made as though the computer was at one altitude sec-
tor higher. This adds in an extra level of conservatism.
f. Profile recording interval: The Quantum can record depth measurements
every 15 or 30 seconds. If set to 15, memory capacity is cut in half.
g. Water type: Actual depth can differ based on the salinity of the water. If you
are diving in a fresh water lake or river, set the Quantum to Fresh; if diving in
seawater, set it to Sea.
h. Depth Alarm: If you exceed this depth, the Quantum will give you an audible
warning.
i. Depth Alarm On/Off: Allows you to turn the Depth Alarm on or off. If set to
ON, the icon will be displayed.
j. Dive Time Alarm: If your bottom time exceeds this setting, you will get an
audible warning.
k. Dive Time Alarm On/Off: Allows you to turn the Dive Time Alarm on or off. If
set to ON, the
of 1.4 for Mix 1 and 1.6 for Mix 2.
2
icon will be displayed.
Quantum Owner's Manual
17