Drain System; Electrical Requirements - Maytag 220–VOLT Installation Instructions Manual

Product Dimensions
D
A
B
C
E
F
N
A. 1.09 m (43")
B. 970 mm (38 ⁄ ")
1
8
C. 890 mm (35")
D. 38 mm (1 ⁄ ")
1
2
E. 705 mm (27 ⁄ ")
3
4
F. 650 mm (25 1 ⁄ ")
2
G. Water inlets
H. 180 mm (7")

Drain System

Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 990 mm (39") high
and no higher than 1.83 m (72") from the bottom of the washer.
H
I
Cold
K
J
Hot
G
O
P
L
M
I. Power supply cord
J. Drain hose connector
K. Label
L. 685 mm (27")
M. 133 mm (5 ⁄ ")
1
4
N. 25 mm (1")
O. Water level switch and shaft
P. 127 mm (5")

Electrical Requirements

A 220–240 volt, 50 Hz., AC only, 10-amp, fused electric
n
supply is required. A time-delay fuse or circuit breaker
is recommended. It is recommended that a separate circuit
serving only this appliance be provided.
This washer is equipped with a power supply cord having
n
an earthing plug. The plug should be accessible for
disconnection from the supply.
If the supply cord is damaged, it must be replaced by the
n
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
Using the universal cord included with this washer:
This washer is equipped with a universal cord with
interchangeable mains plugs.
1. Select the appropriate mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
5