Kodak Dryview 5800 User Manual page 32

Troubleshooting
Code
20703 none
20705 none
20706 none
20915 Internal Image Data Transfer
Failed
20919 Internal Image Data Render
Failed
21000 or none
23000
21001 or none
23001
21002 or none
23002
21003 or none
23003
21004 or none
23004
21116 or Film Jam in Area 1: xxxxx
23116 Supply
21118 or xxxxx Supply: Internal
23118 Hardware Failure
3-8
Table 3-5: Condition Codes (Continued)
Web Portal Message User Action
1. Press and hold the Menu Selection button for five
seconds.
2. Press and release the Menu Selection button again
to display the Error Reset menu. Delete the jobs in
the Unprintable Jobs Queue.
1. Press and hold the Menu Selection button for five
seconds. Release the button and the Test Print
Menu displays.
2. Press and release the Menu Selection button again
to display the Error Reset Menu.
3. Check that the 20703 error is highlighted on the
display screen, then press the Enter button.
1. Turn the imager power OFF.
1. Shut down the imager, then start the imager.
2. If the error persists, call for service.
1. Shut down the imager, then start the imager.
2. If the error persists, call for service.
None. The film tray requires attention due to an error.
The specific error is reflected by a separate code.
None. The film tray needs calibration before it can be
used.
None. The film tray is operating in "manual mode,"
which means the image quality is not within the normal
range.
Remove the film saver or the film bag.
Install a film saver before removing the film tray.
See "Film Jam - Code 2x-116".
1. Cover the film tray with the film saver. Remove the
tray from the imager.
2. Re-insert the film tray and remove the film saver.
3. If the error persists, call for service.
2G0733 2011-09-09