Description Of Major Controls; Gear Shift And Throttle Control - Sea Ray 320 Sundancer Owner's Manual

Table of Contents

Advertisement

S
ECTION
9. D
ESCRIPTION OF
C
ONTROLS
A. G
S
T
EAR
HIFT AND
There are two gear shift levers and two throttle
control levers.
The gear shift levers have three positions:
FORWARD, NEUTRAL (center), and REVERSE.
The gear shift levers must be in the NEUTRAL
position when starting the engines. A detent can be
felt when the control is in exact neutral. Forward
and reverse positions should always be in the
full travel extremes in either direction for positive
engagement and minimum wear. Each gear shift
lever can be used independently from the other, for
example, when idling one shift can be put in forward
and the other in reverse for tight maneuvering. Shift
gears only with engines idling.
The throttle controls regulate the RPM of the
engines. Pushing the levers forward will increase
engine RPM. Regulating RPM of the engines will
control the speed of the boat through the water.
1. M
AINTENANCE
Periodically check and seasonally lubricate the
linkages with medium weight oil.
Occasionally it will be necessary to adjust the
tension on the cables to ensure a positive and direct
response of the control lever action.
2. T
A
C
O
DJUST
ABLE
Remove the two (2) screws which attach the
stainless steel dome and lift the dome free of
the unit.
With a screwdriver, turn the adjustment screw
while moving the throttle lever back and forth
until a positive action is obtained.
Repeat the same procedure on the shift lever
detent screw.
320 Sundancer
®
(355 Sundancer
2 • G
ENERAL
M
AJOR
C
HROTTLE
ONTROL
T
:
ENSION
®
)
B
A
OAT
RRANGEMENT
S
& T
C
HIFT
HROTTLE
ONTROLS
(F
.2.11.1)
IG
!
CAUTION
Cockpit can fill with water if boat is moving forward,
when it is put into reverse.
Before shifting into reverse, shift to neutral, wait for
boat to stop moving forward, then shift into reverse.
E
S
& T
NGINE
HIFT
HROTTLE
(F
. 2.11.2)
IG
FORWARD
PORT
STBD
NEUTRAL
REVERSE
TRANSMISSION
CONTROLS
(C
)
ABLE
SHIFT DETENT
ADJUSTMENT
THROTTLE
TENSION
ADJUSTMENT
(ONE EACH SIDE)
COVER SCREW
(ONE EACH SIDE)
F
UNCTIONS
FULL
THROTTLE
PORT
STBD
VARIABLE
IDLE
ENGINE
THROTTLES
2.11

Advertisement

Table of Contents
loading

Table of Contents