Table of Contents
Advertisement
DESCRIPTION
The
KAI-4011/KAI-4021
referred to in this document as the Imager Board, is
designed to be used as part of a two-board set, used in
conjunction with a Timing Generator Board.
offers an Imager Board / Timing Generator Board
package that has been designed and configured to
operate with the KAI-4011/KAI-4021 CCD image sensors.
The Timing Generator Board generates the timing
signals necessary to operate the CCD, and provides the
power required by the Imager Board. The timing signals,
in LVDS format, and the power, are provided to the
Imager Board via the interface connector (J1).
addition, the Timing Generator Board performs the
processing and digitization of the analog video output of
the Imager Board.
INPUT REQUIREMENTS
Input Signals (LVDS)
H1A (+/-)
H1B (+/-)
H2A (+/-)
H2B (+/-)
FDG
R (+/-)
V1 (+/-)
V2 (+/-)
V2B(+/-)
V3RD (+/-)
VES (+/-)
AMP_ENABLE (+/-)
©Eastman Kodak Company, 2005
Imager
Evaluation
Board,
Kodak
Power Supplies
Minimum
+5V_MTR Supply
-5V_MTR Supply
-5.1
VPLUS Supply
VMINUS Supply
Table 1: Power Requirements
Vmin
Vthreshold
0
0
0
0
0
0
0
0
0
0
0
0
Table 2: Signal Level Requirements
www.kodak.com/go/imagers
The KAI-4011/KAI-4021 Imager Board has been designed
to operate the KAI-4011/KAI-4021 CCDs with the
specified performance at 40MHz pixel clocking rate and
nominal operating conditions. (See the KAI-4011/KAI-
4021 performance specifications for details).
For testing and characterization purposes, the KAI-
4011/KAI-4021 Imager board provides the ability to adjust
many of the CCD bias voltages and CCD clock level
voltages by adjusting potentiometers on the board. The
Imager Board provides the means to modify other device
operating parameters (CCD reset clock pulse width, VSS
In
bias voltage) by populating components differently on the
board.
Typical
Maximum
4.9
5
5.1
1400
-5
-4.9
200
18
20
21
175
-21
-20
-18
150
Vmax
Units
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
+/- 0.1
2.4
V
Units
V
mA
V
mA
V
mA
V
mA
Comments
H1A clock
H1B clock
H2A clock
H2B clock
Fast Dump clock
Reset clock
V1 clock
V2 clock
V2B clock
V2 Clock 3
rd
-level
Electronic Shutter
Output Amplifier Enable
Revision 4.0 (MTD/PS-0521) p3
Advertisement
Table of Contents
