Table of Contents
Advertisement
WARNINGS AND ADVISORIES
The Imager Board described in this document is designed for use as part of a two-board set, in conjunction with a Timing
Generator Board.
Kodak offers an Imager Board / Timing Generator Board package that has been designed and
configured to operate with the KAI-4011 and KAI-4021 CCD image sensors.
Purchasers of a Kodak Evaluation Board Kit may, at their discretion, make changes to the Timing Generator Board
firmware. Eastman Kodak can only support firmware developed and supplied by Eastman Kodak. Changes to the
firmware are at the risk of the customer.
When programming the Timing Board, the Imager Board must be disconnected from the Timing Board, by removing the
Board Interface Cable before power is applied. If the Imager Board is connected to the Timing Board during the
reprogramming of the Altera PLD, damage to the Imager Board will occur.
GLOSSARY OF ABBREVIATIONS
AGND
CCD
FDG
HCLK
LVDS
R+ or R-
SMB
VCLK
V3RD
VES
REVISION HISTORY
Revision Number
1
2.0
3.0
4.0
©Eastman Kodak Company, 2005
Analog Ground.
Charge-Coupled Device; also referred as to the image sensor , imager, or device.
Fast Dump Gate; signal drains charge from the Horizontal registers to allow line sampling.
Horizontal Clock
Low Voltage Differential Signaling, per the TIA/EIA-644 and IEEE 1596.3 standards.
Reset Clock
Subminiature video connector, 75Ω characteristic impedance.
Vertical Clock.
rd
Vertical Clock 3
-level voltage; initiates frame readout by transferring charge to vertical registers.
Electronic Shutter control signal.
Description of Changes
Initial Formal Version
Added Warnings and Advisories Section
Added Glossary of Abbreviations
Added Revision History
Document now applies to KAI-4011 and KAI-4021 Imagers.
Added information regarding optional One-Shot.
Added text note on drawings to define ground pins on CCD imager (Product Drawing)
Added metric units to drawing.
www.kodak.com/go/imagers
Revision 4.0 (MTD/PS-0521) p9
Advertisement
Table of Contents
