Connector Assignments And Pinouts; Smb Connectors J2 And J3; Board Interface Connector J1; Table 5: J1 Interface Connector Pin Assignments - Kodak KAI-4011 User Manual

CONNECTOR ASSIGNMENTS AND PINOUTS

SMB CONNECTORS J2 AND J3

The emitter-follower buffered CCD_VOUT signals are driven from the Imager Board via the SMB connectors J2 and J3.
Coaxial cable with a characteristic impedance of 75 Ω should be used to connect the imager board to the Timing Generator
Board to match the series and terminating resistors used on these boards.

BOARD INTERFACE CONNECTOR J1

©Eastman Kodak Company, 2005
Pin Signal
1 N.C.
3 AGND
5 VES+
7 AGND
9 FDG+
11 AGND
13 V3RD+
15 AGND
17 V2B+
19 AGND
21 V2+
23 AGND
25 V1+
27 AGND
29 R+
31 AGND
33 H2B+
35 AGND
37 H2A+
39 AGND
41 H1B+
43 AGND
45 H1A+
47 N.C.
49 AGND
51 N.C.
53 VMINUS_MTR
55 N.C.
57 AGND
59 AMP_ENABLE+
61 -5V_MTR
63 N.C.
65 AGND
67 N.C.
69 +5V_MTR
71 N.C.
73 AGND
75 N.C.
77 VPLUS_MTR
79 N.C.

Table 5: J1 Interface Connector Pin Assignments

www.kodak.com/go/imagers
Pin Signal
2 N.C.
4 AGND
6 VES-
8 AGND
10 FDG-
12 AGND
14 V3RD-
16 AGND
18 V2B-
20 AGND
22 V2-
24 AGND
26 V1-
28 AGND
30 R-
32 AGND
34 H2B-
36 AGND
38 H2A-
40 AGND
42 H1B-
44 AGND
46 H1A-
48 N.C.
50 AGND
52 N.C.
54 VMINUS_MTR
56 N.C.
58 AGND
60 AMP_ENABLE-
62 -5V_MTR
64 N.C.
66 AGND
68 N.C.
70 +5V_MTR
72 N.C.
74 AGND
76 N.C.
78 VPLUS_MTR
80 N.C.
Revision 4.0 (MTD/PS-0521) p8