Table of Contents
Advertisement
Controller operations
Stripping the wire
O
nce your track is assem-
bled and the lockon is
securely attached, you can connect the
wires from the controller to the lockon.
First you'll want to check the ends of
the wires to make sure that the insulation
is stripped back about 1⁄4" to 3⁄8". To strip
the wires, use a pair of wire strippers or a
sharp knife.
Caution: Only an adult should perform this task! Always use care when stripping wires.
Attaching the controller wires to the lockon
N
ow you'll need to insert a controller
wire into each of the two spring clips on
the lockon.
It's easy! Depress the spring clip with your
finger and insert the bare end of the wire
into the exposed opening. Release the spring
clip. Give the wire a little tug to make sure
it's secure. Repeat these steps with the other
spring clip. Next, insert the small plug end
Make sure that the bare end of
each wire is securely attached
to the spring clip.
of the power pack into the back of your con-
troller, and plug the other end into a stan-
dard outlet.
If the whistle fails to operate
Note!
when you press the whistle button
on your controller (see page 8), remove the
wires from the lockon and reinsert each one
into the opposite clip to reverse polarity.
Plug power pack
into standard
wall outlet
7
Plug this end into
back of controller.
Advertisement
Table of Contents
