Troubleshooting - Interlogix TVM-2700 User Manual

Monitor stand
attached here
The monitor's installation surface is
compatible with other types of VESA standard
stands.
VESA mount specifications:
Model Specifications
TVM-2700 VESA standard: 100 x
100 mm and 200 x
100 mm
(3.94 x 3.94 in. and 7.87 x
3.94 in.)
Screw thread: M4 screw
Length: 8.0 mm
TVM-3200 VESA standard: 200 x
200 mm and 400 x
200 mm
(7.87 x 7.87 in. and 15.75
x 7.87 in.)
Screw thread: M5 screw
Length: 8.0 mm
VESA standard: 200 x
TVM-4200
200 mm and 400 x
200 mm
(7.87 x 7.87 in. and 15.75
x 7.87 in.)
Screw thread: M5 screw
Length: 8.0 mm
User Manual
Face of monitor
stand arm

Troubleshooting

Symptom Check
Picture is jittery Adjust
screen position and adjust
the Clock value carefully
until there is no noise
displayed.
No picture Check if the power switch
and computer power
switch are in the On
position.
Check if the signal cable is
correctly connected to the
video card.
Check if the pins of the D
sub-connector are not
bent.
Check if the computer is in
the power- saving mode.
POWER LED is Check if the power switch
not lit is in the On position.
Check if the power cord is
correctly connected.
Image is Check if the signal cable is
unstable suitable to the video card.
Image is not Adjust
centered, too Center
small, or too image.
large
Picture bounces Keep the devices that may
or a wave cause electrical
pattern is interference away from the
present in the monitor.
picture
See the FCC information
at the front cover of the
manual.
Picture is Adjust
blurred Brightness.
Low sound Adjust the volume on the
OSD menu.
Clock to set the
Clock or H&V
to get the proper
Contrast and
11