LENCO DIGITAL ALARM CLOCK RADIO Instruction Manual page 3

LOCATIONS OF PARTS AND CONTROLS
1. LED display
2. Snooze button
3. Alarm set button
4. Time set button
5. Fast+ set button
6. Slow+ set button
7. Sleep button
8. Battery compartment
POWER SUPPLY
This unit is designed to operate from AC230~50Hz household mains supply. The 9V type (1x006p) battery is used for
clock back up only.
Note: When inserted a back up battery the unit will conserve the settings during power outage.
the disconnect device shall remain readily operable.
LISTEN TO THE RADIO
1. Slide the Function Switch to "ON" position.
2. Adjust the Volume Control into the desired listening level and select your favourite station
the Tuning control.
3. To turn off the radio, slide the Function Switch to "OFF" position.
TO SET THE TIME
1. Press and hold button "TImE".
2. Press "FAST+" for fast increment minute up to 59 and then increment the hour.
3. Press "SLOW+" for normal minute increment. If minute goes to 59 then hour will
increment one step.
4. Release button "TIME", the correct time is shown on the display.
CR3300 LENCO ENG FM IM 230V RED 3 3
9. Dial scale
10. volume control
11. Tuning control
12. Function switch
13. Alarm indicator
14. Wire Antenna
15. 230V power supply cable
16. Speaker
GB 2
with
3/5/2009 5:36:52 PM