Control Features - GE APN08 Series Technical Service Manual

g p
Cool
Mode
Timer On
Timer Off
Air Conditioner Control
ON/OFF Pad
Turns the air conditioner on and off.
Display
Shows the room temperature. Also shows the
set temperature while setting the temperature
in COOL mode or the set time while setting
TIMER ON or TIMER OFF.
NOTE: The display will change to show the
room temperature after settings have been
made. To recall the set cooling temperature,
press the
setting, press the TIMER ON pad or the TIMER
OFF pad for the timer that is set.
MODE
Use to set the air conditioner to COOL, DRY
or FAN mode.
Increase
Use to set temperature when in COOL mode
or to set a time with the timer feature.
FAN Pad
Use to set the fan speed to LOW, MEDIUM or HIGH.
CIRCULAIRE
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn on
until the desired air direction is obtained,
then turn it off.
TIMER Pad
ON—The air conditioner can be set to
automatically come on in 1/2 (0.5) to 24 hours
at its previous setting. The unit must be on
while setting TIMER ON.
1. Press the POWER (ON/OFF) pad.
2. Press the TIMER ON pad. The TIMER ON
light will blink.
3. Press the
time for the unit to start. (Each time you
touch the
advance by 30 minutes between 0 and 10 hours
and by one hour between 10 and 24 hours.)
4. Press the TIMER ON pad again to start the timer.
5. Press the POWER (ON/OFF) pad to turn the
unit off.

Control Features

Dry Fan Low Medium High
Mode Mode Fan Fan Fan
On On On On On On
or pad. To recall the timer
/Decrease Pads
or pad to set the desired
or pads, the set time will
p
TIMER Pad (cont.)
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1/2 (0.5)
to 24 hours.
1. Press the TIMER OFF pad. The TIMER OFF
light will blink.
2. Press the
time for the unit to stop. (Each time you
touch the
advance by 30 minutes between 0 and 10
hours and by one hour between 10 and 24
hours.)
3. Press the TIMER OFF pad again to start
the timer.
After settings have been made, the display will
change back to show the room temperature.
NOTE: Both timers may be set, in combination,
to turn the unit on and off as desired.
To cancel the timer, press and hold the TIMER
ON or TIMER OFF pad (depending on the
timer(s) set) until its indicator light goes off.
Remote Control Signal Receiver
Water Full Indicator Light
When the Water Full Indicator Light begins
blinking, the unit has reached maximum
water collection level.
If water level does not lower in 40 minutes,
the unit will power off and it must be
manually drained.
1. Unplug the power cord and roll the unit
to a drain or outside.
2. Pull out the drain cap from the back
bottom edge and allow water to drain
from the unit.
3. Replace the drain cap and put the unit
back into operation.
NOTE: The unit is designed to automatically
evaporate water collected in normal settings.
However, in very humid settings, the unit may
occasionally need to be drained.
– 8 –
g
Remote Control
or pad to set the desired
or pads, the set time will