Programming; One Or Two-Stage Cooking/Defrosting; Programming One Or Two-Stage Cooking/Defrosting; Cook Count Feature - Amana Menumaster CSNAC8 Series Owner's Manual

Programming

One or Two-Stage Cooking/Defrosting

(6,1,4)
Program pads to heat food up to 39 minutes 59 seconds
at 100 percent power or defrost power level.
1. Open oven door.
2. Press 6, 1, and 4 pad to enter programming mode.
3. Close oven door.
• "PROG" displays indicating programming mode.
4. Press number pad to be reprogrammed.
• Oven shows pad number, heating time and
Cook/Defrost indicator in display.
5. Enter required time:
Press pad 1
to change seconds
Press pad 2
to change tens of seconds "00:10"
Press pad 3
to change minutes
Press pad 4
to change tens of minutes "10:00"
6. Press DEFROST or 100% POWER pad for desired
power level.
• "V" appears over "DEF." or inverted "V" under
"100%" to indicate power level.
7. Press 5 pad.
• Repeat steps 5-8 to program stage 2.
• Defrost can be programmed in first stage only.
• Press pad 5 again if no additional stages are
desired.
8. Repeat steps 4-8 to program other pads.
9. Open and close oven door to exit programming
mode.
Summary of One or Two-Stage
Cooking/Defrosting
1. Open door.
2. Press 6,1,4 .
3. Close door.
4. Press number to be programmed.
5. Enter desired time.
6. Press DEFROST or 100% POWER pad.
7. Press 5 pad. Repeat steps 5-8 to program
stage 2.
8. Press 5 pad.
9. Repeat steps 4-9 or open and close door.
Display Reads
"00:01"
"01:00"

Cook Count Feature (6,1,3)

Use oven for tracking operations. Timer memory totals
number of heating cycles for each pad and all pads
combined. Counting starts when oven begins service.
1. Open oven door.
2. Press 6, 1, and 3 pad to enter cook count mode.
3. Close oven door.
• Oven displays "COUNT" and total number of
heating cycles for all pads combined.
4. To obtain count for individual pad, press
desired pad.
5. To exit cook count mode open and close
oven door.
• If door is not opened, oven exits cook count mode
in 60 seconds.
Changing Signal Volume (6,1,6)
Four volume settings are available for end of cycle
signal.
1. Open oven door.
2. Press 6, 1, and 6 pad to enter programming mode.
3. Close door. Volume setting displays.
4. Press pad for desired volume.
1—off
2—low
3—medium
4—high.
5. To exit programming mode open and close oven
door.
7