Toshiba L7300A Digital Series User Manual page 18

SETTING UP YOUR TV
When Encryption is WEP, Key ID setting is
available. Press
c B b
and / to select 1 (default), 2, 3 or 4.
Press B / b to highlight Done and press OK.
When the message "Wireless configuration is
complete." appears on screen, press OK.
NOTE: Settings are not saved if BACK is pressed
before Done is selected.
n
The Advanced Network Setup screen will
appear.
When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On
or Off. (This should usually be set to On.)
When the DHCP function of the router is Off, set
Auto Setup to Off, and set the IP Address DNS
address (es) manually.
Quick Setup Advanced Network Setup
Country
Auto Setup
Location
IP Address
Subnet Mask
Network
Default Gateway
Auto Setup
Smart TV
Primary DNS Address
Channel Tuning
Secondary DNS Address
You can view the fixed MAC address for the TV, if
one is installed.
B b
Press / to highlight Next.
o
Press OK, and Network Connection Test will start.
A message will appear to indicate if the connection
was successful or if could not be completed.
Network Connection Test
Network connection was completed successfully.
NOTE: The result of Network Connection Test
does not always guarantee the connection.
To cancel the Network Connection Test:
Press EXIT while testing.
When the network can be accessed, Software
Upgrade starts automatically. When Software
Upgrade is completed, proceed to the next step.
B b
/ to select Key ID and press
3/5
On
. . .
xxx xxx xx x
xxx xxx xx x . . .
xxx xxx xx x . . .
On
. . .
xxx xxx xx x
. . .
xxx xxx xx x
Previous Next
5/5
OK
p
Press OK, and TV Power On Control screen will
appear. Select Disabled or Enabled and highlight
Next.
Quick Setup
Country
Location
Network
Smart TV
Channel Tuning
q
Press OK, and Companion Device screen will
appear. Select On or Off from Enable Control and
Media Renderer and highlight Next.
r
Press OK.
The Auto Tuning start up screen will appear with
the option to select between DTV and ATV, DTV
or ATV if available. Press
the appropriate mode and press OK.
s
b
Press to highlight Start Scan, and press OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will
indicate the scan status.
You must allow the television to complete the
search.
Auto Tuning - Antenna
Progress
DTV Tune 4 %
ATV Tune Waiting...
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total
number of services found.
T
C c
Press /
ATV (analogue channel) lists.
18
TV Power On Control
We recommend you 'Enable' TV Power On Control
for quick access to Toshiba services. Once enabled
you will be able to view Internet and Menu
systems faster. This mode will result in your TV
using higher power consumption than when
'Disabled'.
TV Power On Control Disabled
Previous Next
c and B /
Found
0
0
Channel: 23
to view the DTV (digital channel) or
1/2
Disabled
Enabled
b to select