Reference; Troubleshooting - Teac HTIB500 User Manual

REFERENCE

Troubleshooting:

Problem Possible Reasons
The plug is not connected properly
No
The socket has no power
power/display
does not turn
The POWER button was not pressed
on
The fuse is broken
If irregular current is output to the
Turns off speakers, the unit turns off for power
surge protection.
Incorrect input source selected
Cables not connected properly
No sound
The sound has been muted or the
master volume is turned down
Source device is not turned on or
playing (in AUX/HDMI input modes)
Cables not connected properly
No sound to
the two main
The sound has been muted or the
L/R speakers
master volume is turned down
Cables not connected properly
No sound to
center or side
surround
Incorrect Channel Mode selected
speakers
The volume
of the center
or side
The volume is too low
surround
speakers are
low
Speakers are not placed correctly
Sound from
surround
Cables are not connected correctly
speakers is
not in order
Disc is defective
Source device is not turned on or
No sound in
playing (in AUX/HDMI input modes)
HDMI Input
Source device is not set to HDMI
Mode
output mode
Solutions
Check power supply and plug
Check socket and power supply
Press the POWER button
Replace the fuse
Check the cable connections and
turn the unit back on
Select the correct source
according to the connection
setup
Make sure the cables are
connected correctly
Press the MUTE button to
unmute or increase the volume
Turn on and start playback on
the source device
Make sure the cables are
connected correctly
Press the MUTE button to
unmute or increase the volume
Make sure the cables are
connected correctly
Press the CH.mode button to
choose the correct sound
channel mode (3.1 or 5.1)
Adjust the volume, including
using the individual speaker
volume controls
Refer to the instructions on setup
Make sure the cables are
connected correctly
Change to a working disc
Turn on and start playback on
the source device
Adjust the Output settings on the
source device
12