Service During Operation; To Change The Lamp; Change Of Carbon Filter - Electrolux ERES31800W Instruction Book

If the system is not be used for a long
period, it is advisable to remove the
filter and empty out the water. Then
place it in a sealed plastic bag. Store
the filter in a freezer. Turn off the water
connection to the refrigerator.
When the refrigerator is to be used
again, rinse the system through
thoroughly by draining off at least three
litres (5 pints) of water. Before re-fitting
the filter, all its parts must be
thoroughly thawed out.
If necessary, all systems containing
water must be sanitized by ordering
the necessary sanitizing kit through
Electrolux Service Force Centre (tel:
+44 8705 929 929) or through our
website www.electrolux.co.uk.

Service during operation

The water filter is replaced as follows:
Place a piece of kitchen tissue or a
dishcloth in the space under the filter.
Remove the filter by turning it
clockwise. A small amount of water will
run out. Dry off and fit the new filter.
See the section "When starting the
water system for the first time".
The water connection does not need
to be switched off when changing the
filter.
Replacement filters can be ordered
from Electrolux Service Force Centre.
See the section "Service and
replacement parts".
The gas cylinder is replaced as follows:
remove the gas cylinder and move
over the adapter to the new cylinder.
The replacement gas cylinder is
obtained through your local dealer.

To change the lamp

The light is switched on automatically
when the door is opened. Before
replacing the light bulb, disconnect the
power plug from the outlet.
Disassemble the lamp by using a
screwdriver in the recess on the lamp
insert.
Assemble a new lamp by guiding it
into a centred position and press until
it snaps.
Use a halogen bulb of the same type,
maximum rating of 20 W.

Change of carbon filter

To maintain the best performance the
carbon filter should be changed once
a year with normal usage.
New carbon filters can be purchased
from your local dealer. The filter is
placed behind the grill and can be
reached by opening the cover. The
cover can be opened by simulta-
neously pressing the lever on the right
of grill (1) and turning the cover
outward (2). The carbon filter is then
pulled out of its slot (3).
The new carbon filter is placed in the
existing slot - The filter should be
handled carefully so fragments don't
loosen from the surface.
1
16