When The Water System Is Started For The First Time - Electrolux ERES31800W Instruction Book

The power plug must be accessible
after installation of the cabinet.
When the water system is started for
the first time.
The following should be carried out
when the refrigerator is correctly
connected to the water supply in the
building:
Open the tap on the water connection
and start up the refrigerator. The water
system main valve opens and the
system starts to fill up. Wait for five
minutes.
Unpack the filter provided and connect
it as follows:
- Remove the filter protective cap and
insert the filter connector into the filter
seat and turn as shown in the
illustration (1) until the filter engages
and the projection on the filter
cartridge is opposite the mark on the
plastic cover. See also the illustration
and the instructions on the inside of
the service hatch.
1
- Unlock the water dispenser. See the
section "The water dispenser
functions" Select carbonated water
and drain off about 1.5 litres (2.5 pints)
of water. There may be some air to
start with.
2
Connect the gas cylinder provided as
follows:
- Take ou t th e gas cylin der from plasti-
bag and screw the gas cylinder into
the adapter (3) for this purpose, which
is located in the valve, doing this by
hand without tools.
3
- Place the gas cylinder with adapter in
the valve and ensure that the valve
bracket hooks are under the
counterhold on the adapter (5). Then
turn up the bracket lever (6) in one
continuous movement. See the
illustration and the instructions on the
inside of the service hatch.
5
- Unlock the water dispenser and drain
off a further 1.5 litres (2.5 pints) of
water or until there are signs that the
carbonated water in the water
dispenser is starting to run.
4
6
24