Service During Operation; Defrosting The Fridge; To Change The Light Bulb; Installation Of Carbon Filter - Electrolux ERES3500 Instruction Booklet

Service during operation

The water filter is replaced as follows:
Place a piece of kitchen tissue or a dishcloth in the space under the filter. Remove the filter by turning it
clockwise. A small amount of water will run out. Dry off and fit the new filter.
See the section "When starting the water system for the first time".
The water connection does not need to be switched off when changing the filter.
Replacement filters can be ordered from Electrolux Service Force Centre. See the section "Service and spare
parts".
The gas cylinder is replaced as follows: remove the gas cylinder and move over the adapter to the new cylinder.
The replacement gas cylinder is obtained through your local dealer.

Defrosting the fridge

The fridge is defrosted automatically every time the
compressor stops. Frost formation can be prevented
by:
· not putting warm foodstuff inside the cabinet.
· avoiding frequently opening the door or keeping
it open too long.

To change the light bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Cut the packaging around the bulb socket.
UV-blocked
G4
Keep the packaging on to hold the bulb when setting
it into the socket. Do not touch the bulb with your
bare fingers. Halogen light bulbs are sensitive to
grease from the skin.
Use a clear, UV-blocked, low-pressure type halogen
20W/12V Low pressure
light bulb. Socket G4. Voltage 12 V. Power rating
20 W/bulb.

Installation of carbon filter

1
To maintain the best performance the carbon filter
should be changed once a year with normal usage.
New carbon filters can be purchased from your local
dealer. The filter is placed behind the grill and can be
reached by opening the cover. The cover can be
opened by simultaneously pressing the lever on the
2
3
right of grill (1) and turning the cover outward (2).
The carbon filter is then pulled out of its slot (3).
The new carbon filter is placed in the existing slot -
The filter should be handled carefully so fragments
don't loosen from the surface.

When the appliance is not in use

Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the appliance is left on, e.g. while on holiday, ask
somebody to check it once in a while to prevent the
food inside from spoiling in case of a power failure.
Electrolux 8183823-00/7
10