Electrolux ERES31800W Instruction Book page 12

The functions of the water-
dispenser
The locking function:
The locking function is activated by the
production plant.
For temporary unlocking:
Keep the button (I) or (J) pressed in for
about three seconds until the yellow
indicator lamp (H) goes out. The lock-
ing function is re-activated automati-
cally after about three seconds.
For permanent unlocking:
Keep the buttons (I) and (J) pressed in
at the same time for about three
seconds. The button (I) or (J) lights up
to indicate unlocking.
To activate the locking function:
Keep the buttons (I) and (J) pressed in
at the same time for about three
seconds. Activation is indicated by the
yellow indicator lamp (H) lighting up.
Selecting and obtaining water:
Before obtaining water, selection is
carried out either by pressing the
button for carbonated water (I) or the
button for ordinary water (J). The
actual choice is indicated by the
button concerned lighting up. The
selection of water can be changed
while the water is running.
Water is obtained by pressing a glass
or other container against the opening
(M). Stop the water flow by moving the
glass or container downwards away
from the opening (M). Any water that
drips or is spilled is collected in the
drip bowl below the water dispenser.
When carbonated water is being
obtained, there is a slight afterflow
when the glass is removed. The drip
bowl can be detached and emptied
when necessary.
Lighting:
The water dispenser lighting (N) goes
on automatically when water is
obtained.
For continuous lighting:
1. Make sure that the water dispenser
is unlocked.
2. Then hold the button for ordinary
water (J) pressed in for about three
seconds until the lighting goes on.
The lighting then goes on with about
50 % of its full intensity.
To switch off the lighting:
1. Ensure that the water dispenser is
unlocked.
2. Then hold the button for ordinary
water (J) pressed in for about three
seconds until the lighting goes out.
Indicator lamp for the water filter:
The water dispenser is fitted with an
indicator lamp (K) which shows when it
is time to change the water filter. When
the indicator lamp stays on, then the
water filter has been utilised to about
80 % of its expected lifetime. In this
situation, it is recommended that you
buy a replacement filter. When the
indicator lamp starts flashing, the
water filter has been utilised to 100%
of its lifetime. Replace the filter without
delay.
After replacing the filter cartridge, see
the section "Service during operation".
The indicator lamp can be switched off
by holding the button for ordinary
water (J) pressed in for about three
seconds until the indicator lamp goes
out.
12