Table of Contents
Advertisement
MAINTENANCE
WARNING:
GREASE FILTERS
The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand,
or by placing it in the dishwasher (use a short cycle and low temperature).
If washed in the dishwasher, the grease filter surface may become matt. This will not cause any reduction
of performance.
• To remove the filter pull out the handle.
After the filter has been washed and dried, replace following the inverse procedure.
REPLACING THE LAMPS
1. Disconnect the hood from the electric power supply.
WARNING:
2. Remove the light hood.
3. Remove the lamp that needs replacing.
Only use PL 11W lamps.
4. Refit the light hood.
FITTING OR REPLACING THE CARBON FILTER (filter models only).
Replace the carbon filter every 4 months. The filter may not be washed or regenerated.
1. Disconnect the hood from the electric power supply.
2. Remove the grease filter.
3. Apply the filter so that it covers the protection grid of the suction motor, ensuring that the S
holes correspond with the hooking pins R on the side of the suction motor protection grid.
4. Turn the carbon filter clockwise to lock in position (bayonet mount).
5. Refit the suction grid or the grease filter.
To remove the carbon filter follow the inverse procedure.
- Use safety gloves.
- Disconnect the appliance from the power supply.
- Wear gloves.
GB7
Advertisement
Table of Contents
