Table of Contents
Advertisement
Quick Links
Introduction
The SBC-8168 is a 4 Stage switch mode charger with MCU controlled constant current pulse Bulk,
PWM (Pulse Width Modulation) Absorption and PWM Float / Maintenance charge. It is suitable for all
types of 12V lead acid batteries including GEL and AGM. It can recondition lightly sulphatd lead acid
battery. Though it is primarily designed for indoor use, it has a splash proof sealed Polycarbonate
casing.
**Please read this manual carefully and follow the instructions**
Features
1.
4 Stage Charge with constant current pulse Bulk, PWM Absorption & Float.
A. Check & Qualifying battery to Desulphate Pulse Charging.
B. Constant current pulse Bulk charge
C. PWM Absorption charge
D. PWM Float / Maintenance charge.
2.
Motorcycle, Cars, and Low Temperature (less than 10°C) Charge Modes
3.
Select and forget operation and can be connected to battery for months.
4.
Auto recover to last selected Charge Mode on return from AC power blackout.
5.
Electronic wrong battery connection, short circuit protections
6.
Over temperature protection from decrease in output current to shut down.
7.
The Microprocessor unit (MCU) controls charging and monitors battery state of charge with
advanced PWM charging which makes it faster and saver charge your battery without
overcharging or undercharging.
Contents
● Smart Charger with lead connector
● Detachable leads with protection cover & crocodile clips
● Detachable leads with protecion cover & ring terminals
Smart Charger SBC - 8168
User's Manual
Advertisement
Table of Contents
Related Manuals for SMART SBC - 8168
Summary of Contents for SMART SBC - 8168
- Page 1 Smart Charger SBC - 8168 User’s Manual Introduction The SBC-8168 is a 4 Stage switch mode charger with MCU controlled constant current pulse Bulk, PWM (Pulse Width Modulation) Absorption and PWM Float / Maintenance charge. It is suitable for all types of 12V lead acid batteries including GEL and AGM.
- Page 2 Warning : ● This charger is designed for only charging 12V lead acid batteries of 5 to 120Ah. ● Do not use this charger for any other purpose ● For indoor use only ● Explosion hazard: A battery being charged could emit explosive gases. ●...
- Page 3 Plug in the charger to AC mains (100 - 240V) wall socket. The indicatiors light up one by one as charger goes through a series of self checks. Then all lights are on together and off to indicate the end of checks except the operation “Standby” indicator. Connect the red output lead to the positive terminal of the battery and the black lead to the negative teminal.
- Page 4 Check Mode and Normal Charging The Charger first checks the battery’s condition , for normal battery this indication extinguishes after a few seconds and charger enters into “Charge Mode” and finally to the “Float/maintenance Mode” when the battery is fully charged. Charging Stages Bulk : This charges the battery up to about 80% full.
-
Page 5: Specifications
Specifications AC Input 100-240V, 50/60Hz~, 1.5A MAX. Maximum Output Charging Current Max. Power Efficiency >78% Maximum Output Charging Current for Car/Low Temp. Mode Maximum Output Charging Current for Motorcycle Mode 1.5A Absorption Voltage (Motor cycle/Car Mode) 14.4V Absorption Voltage (Low Temperature Mode) 14.7V Construction IP-45 (splash-proof) , poly-carbonate...
Need help?
Do you have a question about the SBC - 8168 and is the answer not in the manual?
Questions and answers