Door Gasket; Door Handle; Drum Glide And Upper Seal; Lower Drum Seal - GE DBL333 Technical Service Manual

Apply a bead of WH60X20 adhesive on the air duct
seal and position it on the air duct. Reinstall the lint
trap cover and filter, front and top panel.

Door Gasket

The door gasket is secured to the door panel by
tabs. To replace the gasket, pull the old gasket off
the inner door panel, align the new gasket tabs with
the slots in the door and press the gasket into place.

Door Handle

The door handle is secured to the outer door panel
by tabs. To replace the door handle, remove the
door from the front panel and remove the screws
from the sides and bottom of the door. Separate
the inner and outer door panels. Release the tabs
that secure the door handle to the front panel.

Drum Glide and Upper Seal

The drum glide is glued to the top outer edge of the
door opening and is a part of the felt upper drum
seal. To replace the drum glide/upper seal assembly,
raise the top panel, remove the two Phillips screws
on the front panel and pull the front panel towards
you. Remove the old seal assembly and glue the
new seal in place using WH60X20 adhesive.
Reinstall the front and the top panels.
Drum Glide and Upper Seal

Lower Drum Seal

The lower drum seal is glued in place around the
outer lower edge of the door opening on the front
panel. To replace the lower seal, remove the top
panel and the front panel. Remove the old seal and
glue a new seal in place. Reinstall the front and top
panels.
Rear Access Panel
The rear access panel allows access to view the
motor, centrifugal switch, idler pulley assembly, belt
and belt switch. The panel is secured to the back by
two Phillips screws.
NOTE: Located on the rear of the dryer is a heat
deflector shield. The purpose of the shield is to
prevent someone from coming in contact with the
hot part of the cabinet near the heater. If you remove
the shield for any reason, make certain to reinstall
the shield upon dryer reassembly.
7
Mini Manual
Heat Deflector Shield
Rear Access Panel