Using A Booster Battery (Jump Starting)
5.
Connect the end of the first cable (1) to the positive (+) terminal of the booster battery. Connect the other
end of the same cable (2) to the positive terminal of the vehicle battery. See DANGER "Battery – Explosive
gases!..." in General Warnings on page 12.
6.
Connect the end of the second cable (3) to the negative (–) terminal of the booster battery. Connect the other end
of the same cable (4) to the battery frame ground.
7.
Sit in the driver's seat and start the engine.
8.
After the engine has started, remove the frame ground (–) cable (4) first. Remove the cable from the positive
terminal (2). Then remove the cables from the booster battery. See following CAUTION.
CAUTION
• The alternator can be damaged if the following actions occur:
– Engine is operated with battery cables disconnected.
– Booster cables are connected wrong.
223
Figure 46 Jump Starting
Page 58
CARRYALL 1500/1700 and XRT 1550/1550 SE All-Wheel Drive Owner's Manual
1