Club Car CARRYALL 1500 Owner's Manual page 50

Engine Oil
203
Figure 33 Add Engine Oil – Gasoline Vehicles
Engine Oil Filling
1. Add engine oil (Figure 33 or Figure 34). With filter change, the engine requires the following amounts:
– Kawasaki gasoline engines: 1 qt and 19 fl-oz (1.5 L) of oil per change.
– Kubota diesel engines: 3 qt (2.8 L) of oil per change.
2. Refer to oil viscosity guidelines for selection of oil grade (Figure 35 or Figure 36). See following CAUTION.
CAUTION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or result in
damage to the engine.
3. Install the oil filler cap.
4. Connect battery and spark plug (Gas only) wires. See Connecting the Battery – Gasoline/Diesel Vehicle
on page 14.
5. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for three minutes and check
for leaks. Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If the filter
leaks, tighten an additional 1/4 turn and retest. If the oil drain plug leaks, re-torque and retest.
NOTE: Wait a few minutes after turning off the engine before removing the dipstick.
6. Remove the dipstick and check the engine oil as a final step. Replace the dipstick.
Page 48 CARRYALL 1500/1700 and XRT 1550/1550 SE All-Wheel Drive Owner's Manual
212
Figure 34 Add Engine Oil – Diesel Vehicles