Table of Contents
Advertisement
4. Unfasten the front panel from the display pedestal.
5. Pass the connector from the card case through the hole in the display pedestal.
Front panel
6. Set the RP Board (14P0298) in the top slot of the pcb card case. See page 4-7
for the location of the pcb card case.
7. Run the connector from the card case in front of the GYRO CONVERTER
Board.
8. Plug the connector in J1 on the RP Board.
9. Fasten the ground wire from the connector at the location shown below.
RP Board
ARP Board
Figure 4-11 Display pedestal, top view
Figure 4-10 Display pedestal
GYRO
INT Board
CONVERTER
Board
Fasten ground wire from connector to this screw.
(TOP VIEW)
SPU Board
J1
Route cable between ARP and SPU Boards.
(FRONT VIEW)
4-11
Control section of
display unit
RP connector
FRONT
Advertisement
Table of Contents
