Assembly - Fisher CZ-20 Quicksilver Operating Manual

ASSEMBLY

Control Housing
Control Panel
Target I.D.
Foam hand
Adjustable arm rest
Arm-rest
1. Remove the headphone, handle and search-
coil assemblies from the carrying case. Be careful
not to damage the foam-rubber inserts or put any
strain on the cable connections.
2. Adjust the lower stem to the approximate length
you will be using: extended for stand-up use or as
short as possible for diving. To extend the lower
stem, push in the spring lock, pull out the lower stem
and let the spring lock snap into another hole.
3. Unwind just enough cable to attach the search
coil to the lower stem.
4. Remove the bolt and wing nut from the search
coil. Line up the hole in the lower stem between
the two holes in the search coil "ears." Attach the
coil to the stem with the bolt and wing nut and
finger tighten.
5. The arm rest may be repositioned for maximum
comfort by removing the arm-rest screws, sliding
the arm rest to the next screw hole and re-installing
the arm-rest screws.
Your Fisher CZ-20 QuickSilver is built to last for years.
Fiberglass upper
Battery access
Submersible
8-inch Spider
Nylon Wing nut
Fiberglass
reinforced
nylon lower
7-foot Search Coil
Headphone
5