Assembly - Fisher 1280-X Aquanaut Operating Manual

ASSEMBLY

Battery Access Panel
Control Panel
LED (Light Emitting Diode)
Adjustable
Arm Rest
Arm Rest Screws
Please save all packing materials for later shipping. Most
important, notice the styrofoam face plate cover. Impact to the
knobs will break the shafts and result in leakage. Repack with
styrofoam cover.
1. Remove the headphone, handle and searchcoil
assemblies from the shipping carton. Be careful not to
damage the foam rubber inserts or put any strain on the
cable connections.
2. Adjust the stem to the approximate length you will be
using, extended for stand-up use or, as short as possible
for diving. To extend the lower stem, rotate the locking
collar of the middle stem fully in the counterclockwise
direction. Push in the spring lock, pull out the lower stem
and let the spring lock snap into another hole.
3. If you will be using the 1280-X on the handle, and not
body mounted, wind the searchcoil cable around the
handle assembly as shown in the diagram above. Secure
the cable with the two Velcro straps included with your
1280-X. Make sure there is some slack at the control
housing end and enough slack at the other end to attach
the searchcoil.
4. Remove the Derlin bolt and nylon wing nut from the
searchcoil. Line up the hole in the stem between the
two holes in the searchcoil "ears". Attach the coil to the
stem with the bolt and wing nut and finger tighten.
4
Spring Lock (Not visible)
8-inch
Spider Coil
Derlin Screw and
Nylon Wing Nut
Lower Stem
Middle Stem
Searchcoil Cable
Waterproof
Headphones
Upper Stem