The Refrigerator/Freezer Needs Air; Appliance Alignment; Electrical Connection - AEG SANTO Operating Instructions Manual

The refrigerator/freezer needs air

Air is fed under the door through
the vent slots in the base and is
exhausted upwards along the
back wall. To ensure proper air cir-
culation never cover or alter the
vent openings.
Attention! If the appliance is
installed under, for example, a
hanging cabinet, a clearance of at
least 5 cm between the top of the
appliance and the cabinet above it
must be maintained.

Appliance Alignment

The appliance must have a solid, level footing. Please compensate for
unevenness in the floor by turning the two adjustable feet at the front
in or out.

Electrical Connection

A properly installed socket outlet with earthing contact is required for
electrical connection. Electrical fuse protection must be of at least 10
ampere.
If the outlet socket is no longer accessible after installation of the
appliance, appropriate measures must be taken during electrical instal-
lation to assure that the appliance can be disconnected from the mains
(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,
with a contact opening of at least 3 mm).
Before initial start-up, refer to the appliance serial plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.:
(i.e. 230 volts alternating current, 50 Hertz)
The serial plate is inside the appliance at the left.
32
AC 230 V 50 Hz or
230 V~50 Hz