Batteries - Minelab Explorer User Manual

Minelab metal detector
Table of Contents

Advertisement

THE MINELAB EXPLORER
www.minelab.com
INCORRECT
CORRECT
1
1
to
8
5
Figure 2.16
2
Figure 2.17
Removing the coil cable
Figure 2.18 Removing yoke from search coil
22
REPLACING AND FITTING THE SEARCH COIL
(Figure 2.16) Gently pull the coil cable from the channel
STEP 4
underneath the lower shaft.
(Figure 2.18) Loosen the yoke nut and carefully remove the
STEP 5
bolt from the yoke bracket. This removes the yoke from the
search coil. Be careful not to lose the two plastic washers.
Replace the search coil. Be careful not to damage the
STEP 6
thread of the nut by over-tightening.
(Figure 2.17). Starting at the top of the lower shaft, carefully
STEP 7
feed the coil cable back into the channel at the rear of the
lower shaft so that the curled cable is in line with the shaft.
1
1
There should be
to
inch (3-5mm) of cable exposed
8
5
between the cable curls and the start of the lower shaft. Once
this is completed you should be able to see approximately 6
inches (150mm) of cable between the coil yoke and the
search coil. This is the slack necessary to allow adjustment to
the angle of the search coil.
To replace the coil cable access panel ensure that the
STEP 8
coil cable aligns with the semicircular hole at the side of
the coil yoke and gently ease the coil cable access panel
into the top of the recess until its prongs are well within
the recess. Check again to ensure that the cable is snugly
lodged in the semicircular hole.
(Detail in Figure 2.15). Using a screwdriver in the slot, prize
STEP 9
the panel back flush into place.
Reconnect cable to control box (as directed in
STEP 10
Connecting the shaft assembly, page 16).
NOTE
If you have difficulty retrieving coil cable from
within the upprt shaft it will be necessary to shorten the
overall shaft length to allow the necessary slack.
3

Batteries

The Explorer is powered by alkaline
batteries or a rechargeable Nickel Metal
Hydride (NiMH) battery pack. This
chapter provides details on battery
installation, use and performance.
THE MINELAB EXPLORER
3
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Explorer sExplorer xs

Table of Contents