Traxxas XO-1 64077 Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. XO-1 64077
  6. Owner's manual

Traxxas XO-1 64077 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

MODEL 64077
OWNER
S MANUAL
'

Advertisement

Table of Contents
loading

Related Manuals for Traxxas XO-1 64077

Summary of Contents for Traxxas XO-1 64077

  • Page 1 MODEL 64077 OWNER S MANUAL ’...

  • Page 2: Table Of Contents

    Entire contents ©2014 Traxxas. Traxxas, Ready-To-Race, Ready-To-Win, XO-1 and ProGraphix are trademarks or registered Traxxas Internet: trademarks of Traxxas. Other brand names and marks are the property of their respective holders and are used only for purposes 6200 Traxxas Way Traxxas.com of identification.

  • Page 3: Safety Precautions

    If you as the user do not accept liability of ownership, Traxxas requests that you do not use this product. Do not open any of the enclosed materials. Return the model to your hobby dealer. Your hobby dealer absolutely cannot accept an item for return or exchange after it has been run or is otherwise no longer in as-new condition.
  • Page 4 SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy Only drive the XO-1 on a closed course with safety your new model. The precautions outlined barricades and pedestrian access controls. This is to prevent All instructions and...
  • Page 5 4.2V, resulting in cell cause fire and personal injury. Traxxas LiPo Power Cells feature a separate balancing port that damage and potential fire. isolates each cell in a pack and charges each cell independently.

  • Page 6: Before You Proceed

    The XO-1 is manufactured by Traxxas If you have any questions about your model or its operation, and is backed by full Traxxas factory support. The installed Mamba call the Traxxas Technical Support line toll-free at:...

  • Page 7: Tools, Supplies, And Required Equipment

    4 AA alkaline LiPo Balance Charger Two battery packs with Traxxas High-Current Connectors batteries EZ-Peak Plus recommended (Part#2933) Traxxas Power Cell LiPo batteries recommended, see page 13 REQUIRED FOR 1 00mph OPERATION (see page • Optional Pinion Gear • 100mph Splitter •...

  • Page 8: Anatomy Of The

    Rear Body Mount Antenna Mount Diffuser Steering Battery Servo Temperature Hold-Down Turnbuckle Foam Sensor Turnbuckle (Rear Camber Link) Bumper Traxxas Motor (Toe Link) High-Current Front Rear Shock Tower Connector Half Shaft Motor Mount Canard Splitter Spur Gear Rear Suspension Arm Cooling Duct...

  • Page 9: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start is NOT a substitute for reading the 1.

  • Page 10: Traxxas Tq I

    INTRODUCTION Brushless Motor - A D/C brushless motor replaces the brushed motor’s traditional commutator and brush arrangement with intelligent Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals electronics that energize the electromagnetic windings in sequence Traxxas Link ™...

  • Page 11: Traxxas Tq Radio System

    It is recommended to keep the Traxxas Link – iPhone/iPad/iPod touch application that provides wire inside the body (in the antenna tube) to prevent the chance access to telemetry data and adjustments in the TQi radio system.

  • Page 12: Transmitter And Receiver

    TRAXXAS TQ RADIO SYSTEM Your model is equipped with the TQi 2.4GHz transmitter with the Traxxas Link Wireless Module. The transmitter has two channels for Castle Creations controlling your throttle and steering. The receiver inside the model has 5 output channels. Your model is equipped with one servo and an Motor Specifications electronic speed control.

  • Page 13: Installing Transmitter Batteries

    3S LiPo batteries are to power the TQi transmitter, required to operate the XO-1 at maximum speed. Traxxas Power Cell as they will not provide LiPo batteries are strongly recommended. The following chart lists all...
  • Page 14 2. Insert the hold-down into the lower set of holes in the center accommodate a variety of LiPo are available from your support. If you are installing Traxxas Power Cell 5000mAh 3S battery configurations. From hobby dealer. When using batteries, the hold-downs should be oriented so the side labeled...

  • Page 15: Radio System Controls/Basic Adjustments

    TRAXXAS TQ RADIO SYSTEM RADIO SYSTEM CONTROLS • In order for the transmitter and receiver to bind to one another, the receiver in the model must be turned on within 20 seconds Remember, always turn the of turning on the transmitter. The transmitter LED will flash fast TQi transmitter on first and red indicating a failure to link.

  • Page 16: Using The Radio System

    LiPo cell it detects. with the radio system or any external interference with your With Traxxas Power Cell 3S batteries installed, the speed control radio signal at your location. will beep six times (two 3-cell batteries = 6 cells).
  • Page 17 TRAXXAS TQ RADIO SYSTEM Steering Sensitivity (Exponential) that favor sweeping turns where gentle steering inputs are required. The Multi-Function knob on the TQi transmitter has been The ranges are exaggerated for illustrative purposes. To prevent loss of radio programmed to control Steering Sensitivity (also known as...

  • Page 18: Adjusting The Electronic Speed Control

    ADJUSTING THE SPEED CONTROL Refer to the included Castle Driver’s Ed Guide instruction Disconnect Batteries After Use manual for full speed control operation details. Mamba Monster Extreme Specs Warning: Risk of Fire! Always disconnect the batteries from the speed control when you are finished using Cells: your vehicle.

  • Page 19: Driving Your Model

    Do Not Operate your model in Wet Conditions • Use good, common sense whenever you are driving your model. Your new Traxxas model features a waterproof steering servo Intentionally driving in an abusive and rough manner will only result and receiver box, but the electronic speed control, motor, in poor performance and broken parts.

  • Page 20: Basic Tuning Adjustments

    BASIC TUNING ADJUSTMENTS 1°-2° 1°-2° Once you become familiar with driving your model, you might need to make adjustments for better driving performance All of the toe links are installed on the model so the Adjusting Gear Mesh left-hand thread indicators Incorrect gear mesh is the most common cause of stripped spur point to the same direction.
  • Page 21 Be careful Optional springs available from Traxxas are listed below. Refer to recheck your ride height as to your parts list for a complete part number listing. Higher rate this adjustment will change Do Not Use springs are stiffer.
  • Page 22 ESC. The servo’s output shaft will automatically jump to its center position. If you have questions or need technical assistance, call Traxxas at 1-888-TRAXXAS 6. Install the servo horn onto the servo output shaft. The servo horn should face toward the center of the chassis and be perpendicular (1-888-872-9927) (U.S.

  • Page 23: Maintaining Your Model

    If the bottom of the shock is leaking, then it is time interfere with the motor’s develops play (spur gear movement for a rebuild. The Traxxas rebuild kit for two shocks is part #5562. rotation and damage the that does not also move the drive motor’s internals!
  • Page 24 MAINTAINING YOUR MODEL Suspension and Cush Drive assembly removal Your model was designed with ease of disassembly in mind. The entire front and rear suspension assemblies can be removed from the chassis fully intact with the removal of only a few screws. Refer to the exploded views included in the Service and Support Guide for complete assembly diagrams.

  • Page 25: Advanced Tuning Adjustments

    ADVANCED TUNING ADJUSTMENTS CAMBER GAIN more steering. Raising the roll center on the front and rear equally will Your model has provisions for adjusting the camber gain geometry of increase overall roll resistance without changing the handling balance. the front and rear suspension. “Camber gain” refers to an increase in The default factory locations are designed to make the model easier and camber angle as the suspension is compressed.

  • Page 26: Gearing

    The rear differential is filled with SAE 10,000W. repetitive starting and stopping. 4.51 4.91 5.30 Only use silicone oil in the differentials. Traxxas offers SAE 10,000W, Repetitive starting and stopping with the high-speed gear will 4.36 4.74 30,000W, and 50,000W viscosity oil (see your parts list). The result in motor overheating.
  • Page 27 5. Install the 2.5x12mm screws and tighten securely. 3. Remove the 3x15mm button head screw from the rear tie bar and set aside. If you have questions or need technical assistance, call Traxxas at 1-888-TRAXXAS Rear Differential Removal (1-888-872-9927) (U.S. residents only)
  • Page 28 3. carries our highest skill Installing the 100mph Splitter If you have questions about the XO-1, please contact Traxxas at level rating, 10, and is not The 100mph splitter with canards is required for 100mph running.

  • Page 29: Driving 100Mph

    (D). Make certain you can access the address you provide. 6. The Traxxas Link Wireless Module and the Traxxas Link App are 3. The application will send you an e-mail to confirm your now paired, and will automatically connect when the transmitter registration information.
  • Page 30 OPERATING THE XO-1 AT MAXIMUM SPEED WARNING! Closed Course Only! Car inspection Location is the most important thing to consider when driving As part of the responsibility of ownership, the XO-1 should be RISK OF INJURY OR DEATH 100mph. Only drive the XO-1 at full speed on a closed course where carefully inspected prior to driving at high speeds.

  • Page 31: Tq Advanced Tuning Guide

    30 models total! Traxxas Link provides a visual interface to name when the transmitter trigger is at neutral. Note: Your transmitter is equipped with a the models, customize their settings, attach profiles, and lock them into memory.

  • Page 32: Led Codes

    (on the throttle channel). This allows you to fine- can be changed. This is especially handy if you operate multiple vehicles tune the servo settings to prevent binding caused by the servo moving with a single transmitter via Traxxas Link ™ Model Memory.

  • Page 33: Menu Tree

    3. Press SET. The red LED will blink in single intervals to indicate Steering Dual Rate has been selected. Model Locking Press Unlock Traxxas Link Press 4. Press MENU twice. The red LED will blink three times repeatedly to One Blink Green One Blink Red Four Blinks Green indicate Steering Percentage has been selected.
  • Page 34 Model Lock 1. Turn transmitter off. 5. Press MENU once. The status LED will blink green twice The Traxxas Link Model Memory feature can store up to thirty 2. Hold both MENU and SET. repeatedly. models (receivers) in its memory. If you bind a thirty-first receiver, 3.

  • Page 35: Menu Tree Formulas

    ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
  • Page 36 MODEL 64077 OWNER S MANUAL ’ 6200 Traxxas Way, McKinney, Texas 75070 1-888-TRAXXAS 140408 KC2080-R00...

Table of Contents