Page 2
If you are an ANATOMY OF the turns. The Traxxas Slash hangs it out for an all new way to experienced R/C enthusiast, you will find it helpful and fast. THE SLASH challenge your driving skills.
SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. Operate • Use Neutrally Timed Motors: For reverse use, the motors must have your model sensibly and with care, and it will be exciting, safe, and 0°...
LiPos. on the risks associated with LiPo battery use. Traxxas does not • Store and transport your battery pack(s) in a cool dry place.
Page 6
SAFETY PRECAUTIONS (continued from previous page) • ALWAYS charge batteries in a well-ventilated area. • Allow the battery pack to cool off between runs (before charging). • REMOVE flammable items and combustible materials from the • ALWAYS unplug the charger and disconnect the battery when not charging area.
R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers...
Page 8
ANATOMY OF THE SLASH Toe Link Front Shock Tower Battery Chassis Rear Shock Tower Slipper Clutch Compartment Front Camber Link Electronic Speed Control Battery Spur Gear Hold-Down Shock Steering Pinion Gear Servo Motor Transmission Antenna Mount Front Bumper Rear Bumper Front Receiver Box Rear Camber Link...
QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.
Page 10
TRAXXAS TQ 2.4GHz RADIO SYSTEM INTRODUCTION LiPo - Abbreviation for Lithium Polymer. Rechargeable LiPo battery packs are known for their special chemistry, which Your model includes the TQ 2.4GHz transmitter. When powered Applying the Decals allows extremely high energy density and current handling in a...
Page 11
TRAXXAS TQ 2.4GHz RADIO SYSTEM IMPORTANT RADIO SYSTEM PRECAUTIONS Thermal Shutdown Protection - Temperature sensing electronics are used in the ESC to detect overloading and overheating of the • Do not kink the receiver antenna wire. Kinks in the antenna wire To prevent loss of radio range, transistor circuitry.
Page 12
TRAXXAS TQ 2.4GHz RADIO SYSTEM MODEL WIRING DIAGRAM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. XL-5 Wiring Diagram The transmitter has two channels: Channel one operates the Motor steering, and channel two operates the throttle. The receiver...
Page 13
LiPo and NiMH batteries. One NiMH batteries (Part # 2914) or or 2s LiPo battery equipped with a Traxxas High Current connector is rechargeable batteries, such required. Traxxas Power Cell iD batteries are strongly recommended for as NiMH (nickel-metal hydride) maximum performance and safer charging.
Page 14
Secure, long-lasting, and easy to grip, the Traxxas down over the post. Secure the connector is engineered to extract all the power your battery has to give.
Page 15
TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS Steering reversing procedure: 1. Press and hold the SET button on the transmitter for two Make certain the model’s seconds. The status LED will flash green. receiver antenna is properly 2. Turn and hold the steering wheel to the full left or full right installed before operating position (it does not matter which position you choose).
Page 16
TRAXXAS TQ 2.4GHz RADIO SYSTEM Range-Testing the Radio System USING THE RADIO SYSTEM Before each running session with your model, you should range-test your The TQ 2.4GHz Radio System has been adjusted at the factory for correct Using Reverse: While driving, radio system to ensure that it operates properly.
Page 17
TRAXXAS TQ 2.4GHz RADIO SYSTEM their model at distances farther than a football field (300+ feet). At TQ 2.4GHz Binding Instructions greater distances, you could lose sight of your model and you may For proper operation, the transmitter and receiver must be electronically To prevent loss of radio range, also exceed the radio system’s operating range, which will cause...
ADJUSTING THE ELECTRONIC SPEED CONTROL The XL-5 electronic speed control is equipped with built-in Low-Voltage 2. Connect a fully charged battery pack to the XL-5. Detection. The Low-Voltage Detection circuitry constantly monitors the 3. Turn on the transmitter (with the throttle at neutral). XL-5 Specifications battery voltage.
Page 19
ADJUSTING THE ELECTRONIC SPEED CONTROL 8. The XL-5 is equipped with thermal shutdown protection to guard against Selecting Training Mode (Profile #3: 50% Forward, 100% Brakes, 50% Reverse) overheating caused by excessive current flow. If the operating temperature 1. Connect a fully charged battery pack to the Patented Training Mode exceeds safe limits, the XL-5 will automatically shut down.
Accelerate smoothly • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not subject it to wet (avoiding full throttle starts), with most of the driving being done at higher speeds.
Page 21
4. Blow off the truck with compressed air (optional, but recommended). Wear safety the receiver box. Label which wire is for which channel. glasses when using compressed air. 4. Apply a small bead of silicone grease (Traxxas part 5. Remove the wheels from the truck. #1647) to the wire clamp (B).
ADJUSTING YOUR MODEL Once you become familiar with driving your model, you might need to change to a lower gear ratio. This • Fast Acceleration 14-Tooth Pinion* make adjustments for better driving performance temperature test assumes that All of the toe links are installed on •...
Page 23
ADJUSTING YOUR MODEL ° ° Adjusting the Toe-in setup will add stability and help prevent spin outs. Experiment with Geometry and alignment specs different springs and shock oils to find what works best for your current Do not run your model with the play an important roll in your track conditions.
If the bottom of the shock is leaking, then it condition of the batteries. is time for a rebuild. The Traxxas rebuild kit for two shocks is 8. Check for any loose screws in the chassis structure part #2362.