Power Requirements - Jacuzzi J-315 Owner's Manual

J-300 Series

6.0 Power Requirements

Jacuzzi® spas are designed to provide optimum performance and flexibility
of use when connected to the maximum electrical service listed below. Minor
circuit board modifications can be performed to allow your new spa to accept an
electrical service other than the factory operation setting. Note: Refer to pages
- for circuit board configuration details or contact your authorized Jacuzzi
37 40
dealer.
North American J-335, J-345, J-355, J-365 & J-375 Models (60Hz)
Circuit Breaker (2-Pole):
Number of Wires:
Frequency:
Current Draw:
In 40A configuration, the heater will not operate while either jets pump
*
is running in high speed. Note: pump 2 runs only in high speed.
** In 50A configuration, the heater will not operate while both jets pumps
are running in high speed. This is the factory setting. Note: pump 2 runs
only in high speed.
*** In 60A configuration the heater will operate while both jets pumps are
running in high speed.
North American J-315 & J-325 Convertible Models (60Hz)
Circuit Breaker:
Number of Wires:
Frequency:
Current Draw:
* All Canadian spas must be hard wired per CSA Canadian standards. (page 22)
† In 15A/30A configuration, the heater will not operate while the jets pump
is running in high speed. The factory setting is 120V/15A.
‡ In 40A configuration, remove jumper JP1-2 on the board, to allow the heater
to operate while the jets pump is running in high speed.
‡ Caution (For 4-wire 240VAC Heater Operation): Move the red wire
on the main terminal strip (TB1) from position #1 to position #3. Make
certain wires are connected exactly as shown in Figure-D (Page 14)
before applyng power. Failure to do so will result in damage to the
circuit board and /or related components and void the manufactures's
warranty.
10
240V/40A*
40A
3
60Hz
26A
120V/15A†
15A, 1-Pole
3 (15A GFCI
Cord US Only*)
60Hz
12A
240V/50A** 240V/60A***
50A
3
60Hz
36A
240V/30A†
30A, 2-Pole
4 (Hard Wire 4 (Hard Wire
Only)
60Hz
21A
60A
3
60Hz
45A
240V/40A ‡
40A , 2-Pole
Only)
60Hz
30A