How To Move The Treadmill - Image IMTL13905.0 User Manual

If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
2. Remove the indicated 3/4" Screw (95) and the Access
Door (121) from the bottom of the Console Base (98).
3. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Base (98). Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Base. Attach the receiver to the
plastic posts on the Access Door (121) with the two in-
cluded small screws.
4. Make sure that no wires are pinched. Reattach the
Access Door (121) with the 3/4" Screw (95). Discard the
other wires included with the receiver.

HOW TO MOVE THE TREADMILL

1. Unplug the power cord.
2. Hold the treadmill with your hands in the location shown
by the arrow at the right, and raise the end of the tread-
mill. CAUTION: To decrease the possibility of injury,
bend your legs and keep your back straight. As you
raise the treadmill, make sure to lift with your legs
rather than your back.
3. Push the treadmill to the desired location. To reduce the
risk of injury, use extreme caution while moving the
treadmill.
4. Carefully lower the treadmill until it is resting on the floor.
Small
Screws
98
Small
Cylinder
121
95
9
Wire
A
Wheels