Network Setup - PiXORD P-500 User Manual

6. Network Setup

General Setup
Ethernet Mode: If using static IP, set to "Static" and then setup the following settings. If there is a DHCP
-
server on the network, set to "DHCP", the device will get the following settings from the server
automatically.
- IP Address: Set the IP address of the device.
Subnet Mask: Set the subnet mask.
-
Gateway: Set the IP address of the gateway on the network.
-
MAC Address: Shows the MAC address of the device.
-
- HTTPS: on/off the HTTPS option.
HTTP Port: Change the port if necessary.
-
RTSP Port: Change the port if necessary. Default port is recommended.
-
RTSP Start: Change the port if necessary. Default port is recommended.
-
- RTSP End: Change the port if necessary. Default port is recommended.
DNS1 / DNS2: Set the IP address of the DNS server.
-
Apply: Confirm the settings.
-
42