Table of Contents
Advertisement
If your hob is not working:
1. Check that the zone is switched on.
2. Check that the mains supply has not been switched off.
3. Check that the fuse in the spur has not blown.
In the event of a fault with the hob, please advise CDA Customer Care
of any fault code shown on the display
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012
F : 01949 862 003
E : service@cda.eu
W : www.cda.eu
Troubleshooting
On first use
You observe that
The display shows a series
of digits and symbols on
first connection
Installation blows a fuse or
only one side of the hob
works
The hob produces an
odour during the first
cooking sessions
9
18
Possible Causes
Working normally
The electrical connection
of the hob
is incorrect
New appliance
fast frying steaks
What should you do?
Nothing, the hob will
be ready to use within
approximately 30
seconds
Check that it is set up
properly (see the Electri-
cal Connection section)
Heat a saucepan full of
water on each cooking
zone for 30 minutes
Advertisement
Table of Contents
