Product Sheet; Control Panel; Grease Filters - IKEA Cooker Hood User And Maintenance Handbook

PRODUCT SHEET

1. Control panel.

2. Self-supporting grease filters
(depending on the model).
3. Extractor grille with internal grease filter (depending on
the model).
4. Lighting unit.
Lamp maintenance
1. Disconnect the hood from the power supply.
WARNING: Wear gloves.
2. Open the extractor grille or remove the self-supporting
grease filter (depending on the model). Fig. 1 (a-b).
3. Remove the burnt-out lamp.
Use 40W max. E14 lamps only.
4. Refit the extractor grille or grease filter.
Fitting or replacing the carbon filter
(filter hoods only).
The carbon filter must be changed every four months.
The filter cannot be washed or regenerated.
1. Disconnect the hood from the power supply.
2. Open the extractor grille or remove the self-supporting
grease filter (depending on the model). Fig. 1 (a-b).
3. Fit the filter over the extraction motor protection grille so
that the slots S on the filter match the hooking pins R
located at the sides of the motor protection grille.
4. Turn the carbon filter clockwise to lock it (bayonet fixing).
5. Make sure the internal selector T "Extractor
is set to "Filter ".
6. Refit the extractor grille or grease filter.
To remove the carbon filter, proceed in reverse order.

Grease filters:

The metal grease filter has an unlimited life and must be
cleaned once a month by hand or in a dishwasher at low
temperature and with a short cycle. Cleaning in a dishwasher
may cause discolouring of the grease filter, but its filtering
efficiency is unaffected.
5019 618 33124
D GB F NL
/Filter
E P I GR
Grease filter maintenance:
1. Disconnect the hood from the power supply.
2. Open the extraction grille or remove the self-supporting
grease filter (in the latter case, wash the filter
immediately). Fig. 1 (a-b).
3. Remove the device securing the grease filter. Fig. 3 (e).
4. Remove the dirty grease filter.
5. After changing or washing the grease filter (depending on
the model), refit by proceeding in reverse order, making
sure it covers the entire extraction surface.
CONTROL PANEL
Light button.
The light button has two positions (OFF - ON).
To switch on the lights: move the button to the right.
Fig. 1
Extraction power selection button.
The extraction speed switch has different settings,
depending on the amount of steam and fumes.
To increase the extraction power: move the button to
the right.
"
e
N
S DK
FIN
RUS BG RO
PL
CZ SK H
Fig. 2
Fig. 3