Heat Tent - Dyna-Glo DGB390SNP-D Owner's Manual

OPeraTiOn insTruCTiOns
LiGHTinG THe GriLL WiTH a MaTCH
1. Open the lid
2. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
3. Light the match.
4. Immediately place the lit match through the spaces in the grill gates near the ports of the burner
between the heat tents as shown. Make sure the lit match is close to the burner ports.
5. Press in the control knob that operates the burner and rotate
High position and burner should light immediately.
6. Repeat 2~5 steps to lighting the remaining burners.
7. Adjust burners to desired cooking settings.
Make sure all burner controls are off, except for the burner being lit and the burners
that have been lit.
SHUTDOWN INSTRUCTIONS
1. Turn control knobs
2. Close valve at tank fully by turning
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.
Care anD MainTenanCe
Cooking Grates
The best time to 'burn-off' the cooking grates is after every use (approx. 15 minutes). The grill is already
hot from cooking thus requiring less fuel to obtain necessary temperature for 'burn-off'.
To 'burn off' or heat clean your grill, turn the burners to highest position and run for 15 minutes with the lid
closed. Then turn off the burners and use a wire brush to clean excess food residue from the grates.
The porcelain grates have an enamel finish (similar to glass) and should be handled with care not to chip.
ensure the grill is cool before cleaning and conducting maintenance and with the gas supply
turned off at the LP Gas Cylinder.
CauTiOn
O
clockwise to the OFF position.
clockwise.
CauTiOn
counter-clockwise to
18