Goldair Platinum Series Operating Instructions page 4

Operating your Micathermic Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front,
sides and rear of the appliance.
HEAT CONTROL SWITCH
The control switch positions are:
- Power On/Off
I - Low Heat
II - High Heat
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke. This
odour or smoke is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
TIMER
Set the Timer by turning the dial clockwise to the
desired length of time (0-12 hours).
If you do not wish to use the Timer, turn the dial
clockwise 360 degrees to the "O" position for override
and the heater will continue to run until the On/Off
button is pressed.
WARNING! Take care in positioning your heater,
using the timer will mean the heater will come on
automatically. Fire may result if placed next to
combustible material.
SAFETY DEVICE
This appliance has two protection devices.
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device automatically disconnects &
reconnects the appliance at a pre-set temperature.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble
free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool down
completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the
heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents. In order to get the maximum heat,
the reflector must be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into the
mains supply.
Do not attempt to dismantle the Micathermic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician.
CAUTION
The Micathermic Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
Do not use this heater with a programmer, remote-
control system, separate timer or any other device
that switches the heater on automatically.
IMPORTANT! NEVER COVER THIS HEATER!
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
info@cdbgoldair.com.au
.