Installing And Removing The Activated Carbon Filters; Changing The Bulbs - Gaggenau AW 400720 Operating And Installation Instructions

Activated carbon filter
•
Activated carbon filters bind the odours in
circulating-air mode.
•
Under normal operation (daily 1 to 2 hours) the
activated carbon filters must be replaced
approximately 2x year.
•
The activated carbon filter is available from
specialist outlets, customer service or the
Online Shop (see Optional accessories). Use
original filters only.
•
Activated carbon filters do not contain any
pollutants. They can be disposed of in the
household refuse.
Installing and removing the activated carbon
filters
1 Remove the grease filters (see Removing and
installing the metal-mesh grease filters).
2 Insert the activated carbon filter.
3 Lock the catch.
4 Reinsert the grease filters (see Removing and
installing the metal-mesh grease filters).
14

Changing the bulbs

•
Before changing the bulbs, always follow the
instructions and warnings in the chapter
entitled "Safety instructions"!
•
The description of changing the bulbs applies
to several appliance models.
Note: Observe the warranty regulations in the
enclosed service booklet.
Changing the halogen bulbs
RISK OF INJURY
Halogen bulbs become very hot during operation.
Even some time after the appliance has been
switched off, there is still a risk of burns!
•
Defective bulbs should be replaced immediately
to avoid overloading the remaining bulbs.
•
Before changing the halogen bulbs, ensure that
they have cooled down fully.
1 Carefully remove the bulb ring with a suitable
tool.
2 Replace the defective bulb with a new one of
the same type and equivalent power (see rating
plate).
Note: When inserting halogen bulbs, do not touch
the glass tube. Therefore use a clean cloth when
inserting the bulb.
3 Reinsert the bulb cover.
4 Restore the power supply by inserting the
mains plug or switching on the fuse.