Table of Contents
Advertisement
3-2-3. Connect w¡th DC Power Cable to DC Power Supply
Connect the supplied power cable with fuse to a regulated DC power supply (13.8 VDC)'
Supplied antenna
I
Wide band antenna or
I Single band antenna
Regulated
DC power supply
Fus€ holder
U.S.A. version only
ANT 1
Use this position when a Mobile
antenna is connected to the ANT 1
connector.
ANT 2
Use this position when a wide band
antenna or single band antenna is
connected to the ANT 2 connector.
AUTO
Use this position when both anten-
nas are connected.
r--l
I
- + l
I
External sDeaker
LINE OUT jack
Before connecting the LINE OUT jack, to
¡nterrupt any signal to the built-¡n speaker
install the supplied connector as follows.
1. Remove the 3 screws securing the top
cover.
2. Remove the 2 screws on each side of
the cover.
3. Gently remove the top cover. Be sure
not to disconnect the wire to the
speaker.
4. Insert the supplied connector as
shown.
5. Replace the cover and tighten the
screws to complete the installation.
fi ",""0t
+ @ d
@ @
Advertisement
Table of Contents
