Table of Contents
Advertisement
Installing the Camera
Remove the back from the housing. The mounting tray for the camera is
secured to the housing back. Position the camera and lens on the
camera tray, and then
secure it with the Hold-down
bolt which threads into the
camera's tripod socket.
Use a flathead screwdriver
(recommended) or coin to
tighten the Hold-down bolt
so the camera bottom is
flush against the tray.
Note: Conversion Circuitry
Strobe ID Switch is located
on bottom of camera tray.
Setting the Conversion Circuitry Strobe ID Switch
On the bottom of the camera tray is a switch for setting the DS Substrobe
ID. Set the switch to the Model of DS Substrobe being used.
When using dual strobes of different models such as a DS51 and a
DS161, set the ID switch to DS51 or the smaller strobe.
Strobe ID Switch
Camera Tray
TIGHTEN HOLDOWN BOLT
WITH COIN
OR SCREWDRIVER
50/51
DS
Set
80
DS Substrobes
125
DS
to TTL Mode
160/161
200
CANON
EOS
50D
Hold-down Bolt
7
Advertisement
Table of Contents
