Setting The Conversion Circuitry Strobe Id Switch; Attaching Camera To Camera Tray - Ikelite D90 Instruction Manual

Setting the Conversion Circuitry Strobe ID Switch

On the inside of the housing back is a switch
for setting the DS Substrobe ID. Set the
switch to the Model of DS Substrobe being
used.
When using dual strobes of different models
such as a DS51 and a DS161, set the ID
switch to DS51 or the smaller strobe.
Attaching Camera to the Camera Tray
Remove the back from the housing. The mounting tray for the camera is
secured to the housing back.
Position the camera and
lens on the camera tray, and
then secure it with the
mounting bolt which threads
into the camera's tripod
socket.
Use a flathead screwdriver
(recommended) or coin to
tighten the mounting bolt so
the camera bottom is flush
against the tray.
DS
125
160/
200
ikelite
Camera Tray
DS
50/51
161
80
Set DS Substrobes
to TTL Mode
Nikon
D90
Mounting Bolt
7